Painting New Plaster With Water Based Emulsion Paint

When it comes to painting new plaster and the plasterer has been nice adequate to have left you a nice flat flat surface, then why not compliment the plaster with a top ability paint finish.
To do this we will need determined tools.

Tools
1 x 9" paint roller with a short pile long life sleeve
1 x roller tray or scuttle
1 x roller pole
1 x 3"or 4" paint brush whether the good ability synthetic or pure bristle Hamilton perfection
1x 2.5ltr paint kettle
1 x bucket or old clean 10ltr paint container

Putting Mats

Protection
Dust sheets folded over double, masking tape for pre accomplished surfaces, toady ,bucket of water and cloth to mop up any accidents.

Painting New Plaster With Water Based Emulsion Paint

Materials and sundries
Good ability trade vinyl mat or silk, a ability filler (tetrion), abrasive paper 120 grade, decorators caulk.

When painting new plaster the 1st coat is equally as leading as the top coat if not more.
Because if you don't thin the paint down with water you will have a rough orange peel effect texture that will totally ruin any occasion of a nice flat finish.

Step1
After putting dust sheets down folded duplicate for added security and organizing your tools for use in middle of the room in one spot, empty paint in to a bucket and stir in approx 20% water (to thin the paint down to be able to absorb into the plaster) fill the paint tray to the level don't overfill, and also Half fill the paint kettle for cutting in brush work.

Step2
now your ready to start the 1st coat (mist coat), cut in with the brush all around the room, around door frames above skirting, a right line to the ceiling, around windows, taped up light switches and sockets being particular to feather out the edges of the paint as you go as not to get runs or ridges of paint, and make your cutting in strips about 6" wide. When all the cutting in is done then roll the walls making sure you overlap your cutting in. That is your mist coat complete. Because you thinned the paint down the paint absorbed into the plaster leaving a flat texture.

Step3
Start at 1 point in the room and work from there going all the way round lightly rubbing the wall down of any grit so they feel flat to the hand, then mix up some filler and fill any cracks, dents or holes. Then get a sealant gun and decorators caulk and fill, tops of skirting, sides of door frames and I put a thin caulk bead along the ceiling line to make it easier to get a tight right cutting in line.

Step4
Go around the room and rub down all patches of the filler to a flat flush finish, dust off the skirting and any other horizontal surfaces, then touch in the filled patches with the thinned down emulsion.

Step5
2nd coat can now be applied in the same way as the first, you can use the paint neat or if you slightly thin down with water by about 5% it will give you a smoother desist as the paint is thinner. You will also find it faster and easier to cut in a right line to the ceiling with the paint slightly thinned. I thin my 2nd coat down slightly and roll a section of wall about 6ft wide and exhaust the roller of paint then go back, and back roll(lightly rollover again while paint is whet and roller is exhausted) each section, which takes out the roller texture even more.

Step6
Same as step 5 you can use neat or thin the paint down, when I am trying for the best desist I slightly thin down again and also back roll again. The thinning down ratio is based on using a good ability trade paint

Painting New Plaster With Water Based Emulsion Paint

Make Your stable Into a Man Cave

Have you ever heard of a "man cave"? That is what some men call a room that is just theirs to do anything they want with. This is where they can install a nice big flat screen, a pinball machine, a jukebox, a pool table, or anything else they might want in a room that is theirs and only theirs.

If you are the kind of guy that wants a "man cave", the garage or part of the garage might be the perfect place. Garages are regularly the territory of the man of the house and if you have extra space in your garage, you might want to consider some garage ideas to transform it into a place where you can favorably hang out.

Putting Mats

In order to make the garage real cool, you will need to do something with the floor. If you can personalize the garage floor you will be well on the way to development it a fun place to spend some time. Some guys cover the floor with their popular sports team's logo and make their garage a place dedicated to sports. You can put all sorts of mats and covers on the floor that makes them a lot more livable than the cold cement that is probably there now.

Make Your stable Into a Man Cave

If you don't want to do anything with the floors just to make them look better, you still might want to think about sealing them. While the cold winter month, your car will track in all sorts of dirt, water, and grime and sealing your floor is a good way to safe it. You car may also leak oil and other things from time to time and a garage mat or sealant is always a good idea.

When you select to desist your garage floor, you will be development a big discrepancy in the quality of your garage. When you assess a garage with a nice done floor to one that has not, you will see how much of an revision it is. Just putting mats in the garage can go a long way in development it look good and protecting it from all the harsh elements as well. A nice done garage floor will help to faultless your garage and help with construction your "man cave" too.

Make Your stable Into a Man Cave